DIVERSION CHARGE CONTROL DIP switch settings are in Appendix 2. Step 4 - Remote Temperature Sensor (RTS) For solar battery charging and diversion load control, a remote temperature NOTE: Confirm all dip-switch settings before going to the next installation steps.
The red "DIP" switch labeled SW4 has four individual switches, which are used to set the speed of the processor. The table on the right shows you This setting should be used if there is a known reason for a BIOS error to appear. An example would be a system administrator must remote boot the system.
On-off switching of wireless remote control. Setting when shipped. Before connections are made, the DIP switch should be set to suit the application and the system structure. * DIP switches are moved up or down with something fine and pointed such as a.
For Devices With DIP Switches. Move the IP-RESET switch to the ON position. Press the RESET button to restart the device. For Devices Without DIP Switches. Hold the RESET button for 5 seconds, then release it. The status LED will begin a 3-blink pattern to indicate safe mode. Press and hold the RESET button again for 5 seconds, then release it. 10.
Blue Sea Systems 2146 Remote Control Contura Switch, LED Light, SPDT, On-Off-On is in stock and ready to ship. Order today!
OUTPUT to remote controller Indoor controller board Receives orders from remote controller and tem-perature data from indoor unit. Processes orders and data. Controls indoor and outdoor operation. Self diagnostic function. w System control operation. w Emergency operation. w Set by dip switch on indoor controller board.
Mar 01, 2017 · Press button , all settings go back to the rotary switch settings. Sensor mode return to DIP switch settings. Press button to initiate automatic mode. The sensor starts working and all settings remain as before the light was switched ON/OFF. 1. Press button “Start” to program. 2.
1. SETTING THE FREQUENCY CODE To set the frequency (code), follow these steps Caution! The dip switches on the receiving unit are covered with a rubber cover, remove the rubber cover and then have it replaced after making any changes to the dip switches. A. Setting the code on the transmitter: a. Remove the battery cover.
Do not connect 110 VAC to the gas control valve, on/off switch, or thermostat posts.! The remote control is carefully engineered and MUST be installed only as specified. It is tested safe when installed in accordance with this installation manual If you modify it or any of its components, you may possibly cause a fire hazard.